Ford Focus>> Engines>> Engine dismantling>> Endura-DI engine removal with transmission MTH-75
For performance of these works you will need the lift or a jack corresponding on loading capacity and steady supports, and also a rigid, mobile assembly table. Masterful Fords equip with the special tool for dismantling of a drive of forward wheels 308-192 (16057).
Removal of the power unit carry out in the following order:
- remove wires from plugs of the storage battery;
- remove the battery;
- remove an arm of the storage battery;

Fig. 83. Removal of a cooler of nadduvochny air



- remove a sleeve of a cooler of nadduvochny air and a radiator (fig. 83) , previously plums cooling liquid;
- remove a casing of the air filter;
- remove soaking-up air line;
- remove wires from the generator, candles of an incandescence and the fuel pump;

Fig. 84. Kotaktnye sockets: 1 — the central contact socket; 2 — the contact socket of the switch of light of a backing; 3 — the holder of wires



- separate the central contact socket 1 (fig. 84) and the contact socket of the switch of light of a backing 2 (fig. 84) , remove the holder of wires;
- remove vacuum hoses and the contact socket from the valve of system of a retsirkulyatsiya of the fulfilled gases (EGR);
- remove hoses of system of cooling from the thermostat;
- disconnect hoses of system of cooling from a broad tank and a radiator;
- remove a broad tank;
- lift the car on the lift;
- remove the bottom cover of a belt of a drive of auxiliary units;
- weaken a belt and remove;
- remove an arm of the pump of the hydraulic booster of a steering;
- disconnect топливопроводы, be careful: fuel is under pressure;
- turn on on 5 turns of a nut of fastening of rods of shock-absorbers from two parties;

Fig. 85. Contact sockets



- remove contact sockets, having unclenched their (fig. 85) ;
- again lift the car;
wire cнимите from a starter also disconnect a wire of connection with "weight";
- remove the bottom cover of a radiator;

Fig. 86. Removal of the bottom cross-piece



- disconnect the contact socket from a sound signal, unscrew bolts of fastening of the bottom cross-piece and with a radiator lower down (fig. 86) ;
- disconnect the management mechanism from a transmission, for this purpose turn the basic ring located on an arm, clockwise;
- disconnect steering draft, remove the stabilizer of cross-section stability and the left cross-section lever of a suspension bracket;
- remove the right cross-section lever of a suspension bracket;
- supporting catalytic converter, separate flange connection;
cлейте oil from a transmission then wrap a drain stopper the moment of 25 N · m;
- remove both shaft of a drive of forward wheels as it was described earlier;
- disconnect a tube from the working cylinder of coupling;
- remove a starter;
- fix the engine with a transmission on an assembly table by means of wooden wedges and couplers;
- disconnect both support of the engine;
- carefully lift the car so that from under it it is possible to deduce an assembly table;
- disconnect a transmission from the engine.