Ford Focus>> Brake system>> Brake bracket and pistons of brake cylinders>> Dismantling and assembly of a brake bracket
Dismantling carry out in the following sequence:
- remove antisplash a cover;
- to avoid damage of pistons, put between the piston and a bracket a wooden or synthetic pro-rate;
- leave the valve for air removal by the closed and compressed air squeeze out the piston from the cylinder through an opening under a hose;
- be careful, pistons hit about wooden or synthetic slips;
- pull out pistons from the bracket case;
- check pistons on existence of through corrosion or рисок, otherwise establish new pistons;
- a rough raid of a rust in a forward part of the cylinder erase carefully by means of a trihedral shaber. Thus do not damage a working surface of the cylinder;
- clear all bracket alcohol for lighters or special cleaning liquid of Ate firm;
- blow a bracket the compressed air.
Assembly of a brake bracket carry out in the following sequence:
- the dry case of the cylinders, new cuffs of the piston and pistons moisten before assembly by brake Super DOT-4 liquid;
- establish a new cuff in a pro-point of the piston and pay attention to its elasticity. Check it a finger;
- establish on the piston a new antisplash cover;
- insert evenly two fingers the piston into the cylinder so that the antisplash cover needed to be fixed on a bracket;
- finish installation in sequence of return to removal.