Ford Focus>> Steering>> Replacement of the pump of the hydraulic booster of a steering
As process of replacement of the pump of the hydraulic booster of a steering is identical to all engines, in this section we will stop on pump option with the Zetec-SE engine. Masterful Fords at performance of these works use the following special tool:
- a grip for a teflon ring 211-188 (13-015);
- key 307-242 (17-049).
Removal of the pump of the hydraulic booster of a steering carry out in the following sequence:
- remove a belt of a drive of auxiliary units as it was described earlier;
- lift a forward part of the car and reliably fix on supports;
- remove the pipeline of a cooler of working liquid by means of a special key. Working liquid merge in pure capacity;
- lower the car;
- disconnect feeding tank and take aside;
- remove bringing hose. Working liquid merge in pure capacity;
- disconnect the contact socket from the pressure sensor in hydrosystem of the hydraulic booster;

Fig. 279. Removal of the pressure head pipeline



- remove the pressure head pipeline (fig. 279) ;

Fig. 278. Pump removal



- unscrew bolts of fastening of the pump and remove its (fig. 278) .
Installation of the pump of the hydraulic booster of a steering carry out in the following sequence:
- at installation of the new pump check a teflon prokladochny ring and if necessary replace with the new;
- finish installation in sequence, return to removal;
- remove air from hydrosystem of the hydraulic booster of a steering.