Ford Focus>> Back suspension bracket>> Stabilizer of cross-section stability>> Removal of the stabilizer of cross-section stability
Before the beginning of work measure car height between a bend of a wing and the earth. Remember this size and recheck it after the completion of work. If the difference which cannot be corrected independently turns out, address on the service center Ford.
Removal of the stabilizer carry out in the following sequence:
- disconnect the stabilizer from both cross-section levers;

Fig. 259. Dismantle of the stabilizer of cross-section stability: 1 — a bolt; 2 — a tightening bracket; 3 — the stabilizer; 4 — the plug



- remove two plugs of the stabilizer. For this purpose unscrew bolts 1 (fig. 259) , remove tightening brackets 2, lift the stabilizer 3 and remove it.