Ford Focus>> Forward suspension bracket>> Replacement of the cross-section lever>> Installation
Installation carry out in the following sequence:
- at installation use only new bolts, nuts and washers;

Fig. 244. Fastening of the cross-section lever: 1, 2 — forward bolts; 3 — the bottom fixing bolt



- fixing bolts of the cross-section lever tighten as follows: a nut 1 (fig. 244) previously tighten the moment of 100 N · m, and then tighten on 60 °, a nut 2 tighten the moment of 120 N · m, a bolt 3 previously tighten the moment of 120 N · m then tighten on 90 °. An inhaling of a bolt 3 check a dinamometrichesky key, whether there corresponds the moment of an inhaling of 170 — 230 N · to m.
- do not forget about the heat-shielding screen on the cross-section lever;

Fig. 245. Installation of a spherical support: 1 — a spherical support; 2 — a bolt



- establish a spherical support 1 (fig. 245) and tighten a bolt the 2nd moment of 50 N · m;
- establish a forward wheel;
- finish installation in sequence, return to removal.