Ford Focus>> Forward suspension bracket>> Replacement of a rotary fist>> Removal
Removal of a rotary fist carry out in the following sequence;
- weaken an inhaling of a nut of a nave and nuts of wheels. Thus the assistant should press a brake pedal;
- lift a forward part of the car and establish on support, having reliably fixed, then remove a wheel;

Fig. 238. Removal of the sensor of speed of ABS



- remove the ABS sensor from the holder of an amortizatorny rack ( fig. 238 , the shooter);
- remove a support of a brake hose as it is described, and fix a wire in a wheel niche. Do not bend a brake hose;
- release a lock bolt of a brake disk and remove a disk from a wheel nave;
- release a lock washer in the directed blows of a hammer (a polymeric hammer) or by means of a stripper;
- disconnect a tip of steering draft;

Fig. 239. Removal of a spherical support: 1 — a bolt; 2 — a spherical support



- disconnect a spherical support 2 (fig. 239) on the cross-section lever of a suspension bracket. For this purpose unscrew a bolt 1 and disconnect spherical a support from a rotary fist;
- protect a cover a rag;
- disconnect an amortizatorny rack from a rotary fist;

Fig. 240. Removal of a rotary fist from a drive of wheels by means of a stripper




- finally unscrew a nut of a nave of a wheel and remove a rotary fist by means of a stripper from a shlitsevy part of the external hinge (fig. 240) . It is important to watch, that at this operation the shaft of a drive of wheels was not taken out from the internal CV JOINT;
- fix a drive of wheels a wire in a wheel niche;
- remove a rotary fist together with the wheel bearing.