Ford Focus>> Ignition system>> Work with ignition system



At all works on ignition you should undertake special precautionary measures.

Prevention
The pacemaker at work with system of ignition can get out of hand. Not to endanger itself, entrust this work to the dealer of Ford.

Engine
Candle marking
1,4 l of Zetec-SE in capacity of 55 kW (75 h.p.)
Motorkraft AZFS 22C
1,6 l of Zetec-SE in capacity of 74 kW (100 h.p.)
Motorkraft AZFS 22C
1,8 l of Zetec-E in capacity of 85 kW (115 h.p.)
Motorkraft AYFS 22PР 1
2,0 l of Zetec-E in capacity of 96 kW (130 h.p.)
Motorkraft AYFS 22PР 1
1,8 l of Endura in capacity of 55 kW (75 h.p.)
Motorkraft EZD 37*
1,8 l of Endura-DI in capacity of 66 kW (90 h.p.)
Motorkraft EZD 37*

* Glow plugs.

But if all of you started service of system of ignition, observe the following precautionary measures:
- at all do not concern at the included ignition of current-carrying elements of primary and secondary windings — it is life-threatening;
- constantly switch off ignition at all service works. This situation operates equally both for replacement of candles, and at connection or a detachment of wires or at connection of measuring devices;
- at the included ignition sometimes it is enough even easy rocking of the car for formation of an impulse of a high voltage. Being under a car cowl, you endanger yourselves and, besides, can damage details of system of ignition;
- if you carry out welding works on the car, previously disconnect from plugs of the storage battery both of a wire.