Ford Focus>> Cooling system>> The pump of cooling liquid>> Removal and pump installation on the Endura-DI engine
Removal of the pump carry out in the following sequence:
- disconnect a wire from the negative plug of the storage battery;
- merge cooling liquid from cooling system as it is described earlier;
- remove a pump pulley as it is described earlier, before it weaken a tension of a belt of a drive of auxiliary units and remove it;
- remove a gear belt of a drive of GRM as it is described earlier;
- remove a natyazhitel of a gear belt and a pump pulley as it is described earlier;

Fig. 176. Removal of a support of the engine



- remove an engine support (fig. 176) for what slightly raise the engine;

Fig. 177. Removal of the pump of cooling liquid



- remove the pump (fig. 177) of cooling liquid for what slightly raise the engine;
- remove pump consolidation, again it is impossible to use it.
Installation finish in sequence, return to removal. Before wrapping bolts, establish the pump on a pin. Fixing bolts tighten at first the moment of 10 N · m, fastening of a support of the engine — the moment of 33 N · m and pulley bolts — the moment of 23 N · m. Check before the first start-up of the engine of a phase of a gazoraspredeleniye.